DI-1000 / DI-1100

Manual, Drivers, Datasheet

As a certified OnLogic solution, all detailed product documentation, including user manuals, technical specifications, regulatory information, and software downloads, is available directly on the manufacturer support site linked below.

DI-1000, 6th Generation Intel® Core™ Processor (Skylake-U) High Performance, Compact and Modular Rugged Embedded Computerwww.cincoze.com

Mid Performance & Power-saving (DI Series)｜Fanless PC | Rugged Embedded Computers | Products | Cincozewww.cincoze.com

Replacement Power Connector

If you need an additional mating connector for your system’s power port, you can acquire our CBP123 component from our website, here.

How to Enable Auto Power On

The DI series has two options for auto power on. The easiest and most reliable method is to use the hardware switch on the front. The downside of this method is that the power button is completely disabled. If you shut down the PC, you will need to cycle power to restart it. If that is an issue for your case, use option 2 instead.

Option 1: Hardware

1. Loosen the two Torx T10 screws from the front panel.

2. They will not come out, but the panel will come loose.

   
3. Underneath the panel you will find a switch labeled AT/ATX.

4. Slide the switch to AT mode.

   
5. Auto power on is now enabled.

Option 2: BIOS

1. Power on the system and immediately press the Del key a few times to access the BIOS.

2. Navigate over to the Chipset tab and open the PCH-IO Configuration menu.

   
3. Change the Power Failure option to [Always On].

   
4. Navigate to the Save & Exit tab and choose “Save Changes and Reset”

Troubleshooting

Internal Access

The DI series of products can be opened by the user. This does not void the warranty, however, any damage caused by doing so will not be covered.

How to Clear CMOS

1. Loosen the two Torx T10 screws from the front panel.

2. They will not come out, but the panel will come loose.

   
3. Locate the clear CMOS switch.

   
4. Move the switch to the clear position.

5. Wait 30 seconds.

6. Restore the switch to the normal position. The CMOS is now clear.

mSATA not detected

If the CMOS is cleared or the BIOS is restored to defaults, any mSATA drives will no longer be detected. Changing a setting in the BIOS can correct this.

1. Power on the system and immediately press the Del key a few times to access the BIOS.

2. Navigate over to the Chipset tab and open the PCH-IO Configuration menu.

   
3. Note the 3 slots all set to Mini-PCIe. This works for WiFi cards but not for mSATA storage drives. Change all 3 slots to mSATA mode. If your system is equipped with WiFi, some guess and check will be needed to determine which slot needs to stay in PCIe mode.

   
4. Save changes and reset. The mSATA drive should now be detected.