MC500G-51 / MC600-10 / MC600-11 / MC600-50 / MC600-51 / MC600-52

Technical Resources

Internal Access

The MC600 can be opened by the user. This does not void the warranty, however, any damage caused by doing so will not be covered.

The following steps will walk you through opening your MC600 case, as well as auto-powering on and clearing CMOS.

The case is very simple to open. To do so, remove the two screws from the back and slide the lid off towards the rear.

MC600-10

Motherboard

Drivers

Click here for Drivers

Auto Power On

1. Power on the unit and press the Del key to access the BIOS

2. Navigate to the Chipset tab

3. Change “Restore AC Power Loss” to [Power On]

4. Save changes and exit

5. Auto power on is now enabled

1. Locate the clear CMOS jumper

2. Move the jumper over by 1 pin

3. Wait 30 seconds

4. Restore the jumper to its original position

Access the official from ASRock. This external link provides access to the complete motherboard manual, along with the latest BIOS updates and specific drivers for your system's motherboard (IMB-156).

Warning: Never interrupt a BIOS update. If the update is interrupted, the system may become irreparable. Damage caused as a result of BIOS updates may not be covered by the system's warranty.

You can follow this for installation instructions.

1. Locate the PWR_JP1 jumper indicated by the orange circle

2. Move PWR_JP1 over by 1 pin

3. The unit is now configured for auto power on

1. Locate the clear CMOS jumper

2. Move the jumper over by 1 pin

3. Wait 30 seconds

4. Restore the jumper to its original position

1. Locate the AT/ATX jumper

2. Move it over by 1 pin

3. Auto power on is now enabled

1. Locate the CLRMOS1 jumper

2. Move the jumper over by 1 pin

3. Wait 30 seconds

4. Restore the jumper to its original position

Access the official from ASRock. This external link provides access to the complete motherboard manual, along with the latest BIOS updates and specific drivers for your system's motherboard (E3C226D21).

1. Power on the unit and press the F2 key to access the BIOS

2. Navigate to the Advanced tab

3. Open the South Bridge Configuration menu

4. Change “Restore on AC/Power Loss” to [Power on]

1. Locate the CMOS battery

2. Carefully remove it from the holder

3. Wait 5 minutes

4. Reinsert the battery

Access the official from ASRock. This external link provides access to the complete motherboard manual, along with the latest BIOS updates and specific drivers for your system's motherboard (IMB-195).

1. Locate the AT/ATX jumper

2. Move it over by 1 pin

3. Auto power on is now enabled

1. Locate the CLRMOS1 jumper

2. Move the jumper over by 1 pin

3. Wait 30 seconds

4. Restore the jumper to its original position

For the latest security advisories concerning OnLogic products, including vulnerability disclosures and necessary updates, please refer to our official Security Advisories page. It is recommended to regularly check this resource for critical security information.