As a certified OnLogic solution, all detailed product documentation, including user manuals, technical specifications, regulatory information, and software downloads, is available directly on the manufacturer support site linked below.
The P2002 can be opened by the user. This does not void the warranty, however, any damage caused by doing so will not be covered.
Replacement Power Connector
If you need an additional mating connector for your system’s power port, you can acquire our CBP123 component from our website, here.
Auto Power On
The P2002 has two options for auto power on. In this section we will go over both with instructions.
Option 1: Hardware
The easiest and most reliable method of enabling auto power on for the P2002 is through the hardware, which uses the switch on the side of the unit. Slide the switch to AT mode to enable auto power on.
The downside of this method is that the power button is completely disabled. If you manually shut down the PC, you will need to cycle power to restart it. If that is an issue for your use case, use option 2 instead.
Power on the unit and press the Del key to access the BIOS
Navigate to the Chipset tab
Open the PCH-IO Config menu
Change “Power Fail After G3” to “S0 State”
The P2002 can be opened by the user. This does not void the warranty, however, any damage caused by doing so will not be covered.
Required tools: T10 Torx driver
Remove the 6x torx screws that hold the lid in place
Lift the lid off vertically. Moderate force may be required to break the thermal seal
Set the lid aside
Locate the SW2 switch block
Flip switch #2 into the ON position
Wait 30 seconds
Restore the switch to its original position
The CMOS has now been cleared
NOTE: The unit may power cycle several times before it boots up. This is normal.
Some touchscreens require additional drivers to work on Ubuntu and similar OS distributions. This will guide you through the installation.
