Technical information related to the system's motherboard can be found from the support link below.
The ML100 can be opened by the user. This does not void the warranty, however, any damage caused by doing so will not be covered.
Ensure your body is discharged of any static electricity by touching a grounded metal surface.
Remove the 4x phillips screws on the outside of the case.
Use the tab for leverage to pull the bottom panel off
The internals of the unit can now be accessed
● Locate the PWR_JP1 jumper ● Move it over by 1 pin ● Auto power on is now enabled
Note: This procedure requires opening the case first. See Internal Access section above.
Disconnect the unit from all wire connections (power, USB, ethernet, etc.)
Locate the CLRMOS1 jumper
Move the jumper over by 1 pin
Wait 30 seconds
For the latest security advisories concerning OnLogic products, including vulnerability disclosures and necessary updates, please refer to our official Security Advisories page. It is recommended to regularly check this resource for critical security information.
Restore the jumper to its original position
Close up and power on the system. It may power cycle several times before it begins working again.
