- Remove the existing front plate from the case and install the new front plate in its place.
- Remove the hard drive tray and PCIe riser bracket
- Remove these 5MM standoffs and lift the case so the screws fall out from the bottom. Set screws aside for later.
- Bend tray at marked line until parts separate
- Install hotswap bays to bracket using the included screws
- Install tray in system
- Install the 2nd half of the bracket as shown
- Using the screws from the standoffs removed previously (or spares from the accessory box), install screws up through the bottom of the case to hold the bracket in place
- Connect SATA cables